Bill Henning
- Gesamtaktivitäten 75
- Letzte Aktivität
- Mitglied seit
- Folge ich 0 Benutzer
- Gefolgt von 0 Benutzer
- Stimmen 3
- Abonnements 20
Kommentare
Neueste Aktivität von Bill Henning-
Robert, perhaps I should have said sensitivity is set at HIGH by the Sena configuration software. Even so it did not respond to numerous tap-tap's, either with or without gloves on. In any case sin...
-
An undeserved compliment for sure, but thank you. Turns out a piece of tape over the hole works as well if not better. Just take the clamp off and tape the hole over.
-
Yes, when the headset is in ambient mode (mute) I hear a buzzing in one earpiece more than the other. I have tried three high quality earpieces and the all have it, some less than others but alway...
-
If you are having a problem with tap-tap not working to get into standby mode the Sena guy suggested that perhaps going back to firmware 1.0 might help, since they reduced the motion sensor sensiti...
-
Dgreen, I agree it seems a little bass ackwards the way the USB plug goes in. I may just buy a couple of straight plug cables on Amazon. One other thing to be careful of is that if you yank on an...
-
I just put a piece of medical waterproof adhesive tape over the hole. Very easy to do and I think that will keep the water out.
-
Just contact Sena and ask for a replacement set. They did that for me and have been very good about fixing things in general for myself.
-
+1 on the disconnect problem. Not sure if it is one or both headsets causing the problem. We're just rolling along, my passenger and I, when the intercom just stops working. It takes a shutdown ...
-
I am on my third set of 20s units are they are working fine now. Just got back from a week long trip and the intercom never dropped off. However I did have this problem with set #2. Rider and pa...
-
Wow, sounds like you have tried everything, different earbuds and different units. Why you have this problem and I don't is hard to understand, but it would seem to be the 20s units you have. I ...