Sena

1. Community
2. General Discussion
3. Music Interrupted by general noise

@Diptwattle:  You can disable the motion sensor so that you will no longer hear the "Say a command" voice prompt. For more information, refer to this F.A.Q. http://support.sena.com/entries/10797348...

1. Community
2. General Discussion
3. No commands in music mode?

Perform a Factory Reset on your 20S. To find out how to perform a Factory Reset on the 20S, you can refer to the 20S User's Guide under the Support Documents section here http://www.sena.com/produc...

1. Community
2. General Discussion
3. No commands in music mode?

@Belot77: Yes. The "Hello Sena" voice command can only be used during Standby Mode. You would need to activate the voice command system by double tapping the main unit twice or tapping once on the ...

1. Community
2. General Discussion
3. New 2nd A2DP for 2nd phone

2.  When in group intercom, no one could leave the group by using the double-tap and saying "group intercom".  I don't know of any other way for a person to leave the group.  Is there one?  Since i...

1. Community
2. General Discussion
3. New 2nd A2DP for 2nd phone

@Dan: No it will not interrupt the intercom. GPS Pairing will allow you to hear the instructions from the GPS while talking over the intercom.   @Marc: If you can listen to the music from your Zumo...

1. Community
2. General Discussion
3. New 2nd A2DP for 2nd phone

@Inspector069: We apologize as we were referring to Case #4 in the User's Guide and didn't see the link that you posted about the GPS Pairing configuration. With that said, we have notified our dev...

1. Community
2. General Discussion
3. How to manual search for radio station?

1. Rotate while pressing the Jog Dial clockwise to search up the station dial or counter clockwise to search down the station dial. 2. If the tuner finds a station while searching frequencies, it s...

1. Community
2. General Discussion
3. bluetooth music cutting in and out and phone call quality is terrible.

Michael: Make sure the firmware on the 20S has been updated to the latest version which is v1.6. Then, remove the 20S from the list of Bluetooth devices on your phone. Next. perform a Factory Reset...

1. Community
2. General Discussion
3. Intercom Failing on Paired devise with Pillion

Please contact our Technical Support department for assistance regarding your 20S. You can visit the home page here http://support.sena.com/home to see how to contact them.

1. Community
2. General Discussion
3. Pairing with 2013 R1200RT

Perform a Factory Reset on the 20S and delete any paired devices on your BMW R1200RT to start from the very beginning. Here is a video on how to pair the 20S to a BMW R1200RT.