Keith
- Gesamtaktivitäten 133
- Letzte Aktivität
- Mitglied seit
- Folge ich 0 Benutzer
- Gefolgt von 0 Benutzer
- Stimmen 0
- Abonnements 16
Kommentare
Neueste Aktivität von Keith-
Just an update on my powered off battery life observations. Just to recap. 1. I found that both of my 20S units that were fully charged and put back in the box on 4/25/15 were both drained an doing...
-
Ok. Here's what I just reported to the Sena engineer: ++++++++++++++++++++++++++++++++++++++++++++++++++++++ I just checked both of my 20S units and they are both reporting a high battery level. He...
-
Hi Ken, I'm not ready to put the "turned off" battery life issue to rest just yet. I won't be confident that this isn't an issue until I've gone through at least a few cycles of charging them after...
-
Just FYI. I just did my daily battery check on both units. The unit last recharged on 5/3/15 is now giving 3 LED flashes and responding with "Battery level is medium". So, it lost at least 30% of i...
-
Well, the fully charged to dead in a week is what I have experienced until this last recharge. Both units have managed at least 4X that time and counting since the last recharge....for whatever rea...
-
Hi Ken, Hope everything is ok for you and yours in Texas with all the rain. At this time, I'm inclined to agree with you that 20S battery drain while powered off is NOT an issue. I've checked both ...
-
Just FYI, I sent the Sena engineer I've been working with the same update I gave above on 6/2/15 regarding the one unit now getting 3 LED flashes on power-up after 4 weeks of non-use. Below is the ...
-
Hi Gary. There have been two different battery drain issues discussed on this thread. Stand-by time and powered off battery drain. I agree that getting into the habit of just leaving a 20S unit pow...
-
Just an update to my powered off battery life. As of yesterday (7/12/15), the unit charged on 5/3/15 was still reporting "Battery level is medium" (3 flashes). The unit charged on 5/7/15 was report...
-
Ok. With a full charge, my 20S shut down after 35 hours in stand-by mode running version 1.3. I got less than 24 hours running version 1.2. This is with the unit mounted on a helmet and sitting on ...