Keith
- Gesamtaktivitäten 133
- Letzte Aktivität
- Mitglied seit
- Folge ich 0 Benutzer
- Gefolgt von 0 Benutzer
- Stimmen 0
- Abonnements 16
Kommentare
Neueste Aktivität von Keith-
Well, the fully charged to dead in a week is what I have experienced until this last recharge. Both units have managed at least 4X that time and counting since the last recharge....for whatever rea...
-
Hi Ken, Hope everything is ok for you and yours in Texas with all the rain. At this time, I'm inclined to agree with you that 20S battery drain while powered off is NOT an issue. I've checked both ...
-
Just FYI, I sent the Sena engineer I've been working with the same update I gave above on 6/2/15 regarding the one unit now getting 3 LED flashes on power-up after 4 weeks of non-use. Below is the ...
-
Hi Gary. There have been two different battery drain issues discussed on this thread. Stand-by time and powered off battery drain. I agree that getting into the habit of just leaving a 20S unit pow...
-
Just an update to my powered off battery life. As of yesterday (7/12/15), the unit charged on 5/3/15 was still reporting "Battery level is medium" (3 flashes). The unit charged on 5/7/15 was report...
-
Ok. With a full charge, my 20S shut down after 35 hours in stand-by mode running version 1.3. I got less than 24 hours running version 1.2. This is with the unit mounted on a helmet and sitting on ...
-
Ok. I received the replacements for my two RMA'ed 20S units. They are both S/N 15XXXX units shipped running firmware version 1.3. And they both came with the new cradle that has the aluminum latch....
-
Hello, I sent my battery life findings to Sena. Below is their response: ========================================================================== As noted in the comparison chart from:http://www....
-
Ok. I know I'm beating a dead horse at this point, but I just wanted to report another finding. After testing the battery life of my S/N 15XXXX replacement units, I fully charged both of them and...
-
Hi Ken, I've tested "Hello Sena" enough. It's VERY easy to verify. Turn on the unit, do/say nothing for 90 seconds and then try "Hello Sena". It consistently worked for me with firmware version ...