PI: Freisprecheinrichtung aktivieren und Ausschalten / PI: Activate and deactivate the hands-free system
Hallo,
ich habe gerade ein PI gekauft und versuche es nun zu installieren. Dazu habe ich noch ein paar Fragen.
Die Verbindung zum Handy und das Firmwareupdate für beide PI hat funktioniert. Das Pairen der Freisprecheinrichtung hat auch funktioniert. Das jeweils andere Gerät steht in der Pairingliste. Schalte ich nun die Geräte aus und später wieder ein wird das Handy direkt verbunden, die Geräte sind aber aus der Pairingliste verschwunden. Ich muss wieder neu pairen. Nach dem Einschalten der PI sind die beiden nicht gepairt. Ein 1 Sekunden-Druck auf die "-" -Taste startet auch nicht die Gegensprecheinrichtung. Jetzt muss ich auf beiden PI für 5 Sekunden die "-" - Taste drücken. Das funktioniert. Nach dem nächsten Ein- und Ausschalten muss ich wieder erneut verbinden.
Sollte die Verbindung nicht dauerhaft gespeichert sein, sodass sie nach dem Einschaltendirekt wieder zur Verfügung steht?
Wenn sie dann aber gepairt sind drücke ich eine Sekunde auf die "-" - Taste um die Verbindung zu aktivieren. Dann klappt die Sprachverbindung. Laut Beschreibung sollte jetzt durch das Drücken der "-" -Taste für eine Sekunde die Sprachverbindung wieder ausgeschaltet werden. Das klappt nicht. Die Sprachverbindung bleibt bis zum Ausschalten aktiv, somit kann auch das Handy keine Musik oder Anrufe durchstellen.
Hello, I just bought a PI and am trying to install it now. I have a few more questions about this. The connection to the cell phone and the firmware update for both PIs worked. The pairing of the hands-free system also worked. The other device is in the pairing list. If I switch the devices off and on again later, the cell phone is connected directly, but the devices have disappeared from the pairing list. I have to re-pair again. After turning on the PI, the two are not paired. Pressing the "-" button for 1 second also doesn't start the intercom. Now I have to press the "-" button on both PI for 5 seconds. It is working. After the next power cycle I have to reconnect again. Shouldn't the connection be saved permanently so that it is available again immediately after switching on? But when they are paired, I press the "-" button for a second to activate the connection. Then the voice connection works. According to the description, pressing the "-" key for a second should now switch the voice connection off again. It does not work. The voice connection remains active until it is switched off, so the mobile phone cannot put through any music or calls.
-
Official comment
Hello,
You can attempt a fault reset on the PI by following these steps:
1. Connect the USB charging & data cable to a power supply and plug it into the headset.
2. The headset will automatically turn off, and a fault reset will occur.After the fault reset, make sure to forget the PI on your phone so you can initiate a fresh Bluetooth pairing. If the issue persists, it would be helpful if you could provide your phone model. Keep in mind that Sena devices typically establish connections with phones on a first-come, first-serve basis, so this information will assist us in diagnosing the problem.
Please sign in to leave a comment.
Comments
1 comment