Chris
- Total activity 166
- Last activity
- Member since
- Following 1 user
- Followed by 0 users
- Votes 57
- Subscriptions 43
Comments
Recent activity by Chris Sort by recent activity-
Kevin, with latest firmware the audio intercom sensitivity control works on mesh. I run mine at 1 and that takes care of wind noise in my modular helmet. Are you using open face helmets? If so that...
-
I don't have the 30k but try hey seeena check battery. dont pause just say the sentence. if that works then practice the commands. on model it should be 30k-01 if it works like the 50s.
-
my 20s is 10 years old i think. still works. i did get a new 50s with mesh. Like he said the 20s will not have mesh but a rider with a 50s or 50r can bridge you into a mesh conversation
-
Always after an update do the fault reset on back of unit and then do a factory reset in config menu. clear pairing on your phone and gps, repair to the phone and gps. do not use the garmin smart p...
-
Dave, i had a ticket in with sena about this issue, it was my sole reason to upgrade to the harmon k unit from my older 50s. i did not want to have to keep turning off the mic during mesh just to h...
-
did you figure it out?
-
Dave I saw a SENA press release saying there is a chip shortage and they will discontinue fm on the cheaper models. For 50 series we still get voice commands via "Hey Sena" not hello sena and Fm. I...
-
yes one or 2 depending on conditions
-
Which 50s are you using? 50s-01 or 50s-10? If the original 50s check the mic orientation. The fin should be facing outwards away from lip.Check the groups mic orientation. Then check a setting in t...
-
First try using a port on the back of the computer. If it doesn’t work then or its a laptop you will have to disable the windows driver signature requirement.Press and hold the Shift key on your ke...