Peter

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

Hi RIch, well, that's one difference in our setup, my SR10 isn't paired as either phone or media. I used the multipoint pairing for it (hold the jog wheel on the SMH10 until it says 'intercom pairi...

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

Hi Rich, I just looked through the manual for your radio and I can't find a way to turn BCLO on or off, the only mention of a similar function I see is the VOXonBUSY (menu 20), you might try turnin...

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

Hi Rich, ok, I think I understand what you're talking about now. I read your original message as meaning that the repeater _never_ stops transmitting. Yes, my local repeaters to continue to transmi...

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

Hi Rich, I use a Ham radio myself with the SR10 and I don't notice any of my local repeaters continuing to transmit, they all drop carrier right after the sender does*. I'm new to Ham so I'm mostly...

1. Community
2. Tips & Troubleshooting
3. Are either of the SR10 input jacks noise-gated?

The squeal you're hearing is most likely alternator noise from your bike's electrical system. When you power the SR10 from the bike and connect it to other bike-powered audio devices, you create a ...

1. Community
2. Tips & Troubleshooting
3. What type of Hirose connector is needed for the radio connection on the SR10? will a HR10A work?

Since I have to build a custom ground-loop isolator for my two-way radio, it'd be nice to use the same connector as the SR10 to keep the cabling simple and clean. Getting an actual part number conf...

1. Community
2. Feature Requests and Suggestions
3. SR10 Needs Ground-Loop Isolation

Hey Dan, I'm aware of the ground loop isolators with 3.5mm connectors. I have one for the radar detector but haven't installed it yet. My bigger issue is the two-way radio. I have a ground loop bet...

1. Community
2. Feature Requests and Suggestions
3. Sensitivity control for intercom VOX

I have the same problem, the intercom connection drops off constantly during a VOX conversation. Adding some hysteresis to the VOX sensitivity would help (i.e.: you still need the same sound level ...

1. Community
2. Feature Requests and Suggestions
3. more volume would be nice.

Another +1, the volume is sufficient when riding without earplugs, but with earplugs in, it can't be set loud enough to hear properly.

1. Community
2. Feature Requests and Suggestions
3. Allow the user the option to keep A2DP stream active during SR10 Audio mixing

Let me add a big +1 to this feature request. I'd also like the ability to keep the A2DP stream going during either SR10 input or intercom, just drop the volume of the A2DP stream instead of blankin...