Mathis Brunn

1. Comunidad
2. Tips & Troubleshooting
3. SRL-MESH is not charging but red LED is on

@Kim Eriksson I got mine replaced by warranty last year. Not had any problems since then.

1. Comunidad
2. Tips & Troubleshooting
3. SRL-MESH is not charging but red LED is on

By now I send it in to my dealer. Haven't heard anything for at least 3 weeks. Would be interesting to see if the version for the neotec3 has the same issues.

1. Comunidad
2. General Discussion
3. SRL Mesh Firmware 1.3 - Revision History available ?

I notice the charging LED in the helmet doesn't work anymore, just installed 1.3 with the wifi adapter. Very helpful after it had charging issues anyway /s.

1. Comunidad
2. Tips & Troubleshooting
3. SRL-MESH is not charging but red LED is on

Again... In the evening I plugged it in and set it on the edge of the table. Checked the LED is red. Now in the morning the LED was off and the battery empty. I didn't touch it in the night.

1. Comunidad
2. Tips & Troubleshooting
3. SRL-Mesh Double beep caused by wind noise

I read something about activating the mic in groupchats by blowing against it. Look in the manual if you find something

1. Comunidad
2. Tips & Troubleshooting
3. SRL-MESH is not charging but red LED is on

Alright, will look into it. Sadly today I've got a problem again. Charged it over night to have a full charge and it doesn't even turn on. Plugged it in a couple of seconds then startet it, only ...

1. Comunidad
2. Tips & Troubleshooting
3. SRL-MESH is not charging but red LED is on

Ok, my System seem to work now. I used it yesterday till it ran out of battery (which was just an hour), then in the evening I put it on charge with a 5V 2A charger and the wifi adapter. Today in ...

1. Comunidad
2. Tips & Troubleshooting
3. SRL-MESH is not charging but red LED is on

I have the same problem. First time I wanted to fully charge it. Left it on charge last night and it only went from 40% to 50% on a 5V 1A charger with a normal USB C cable Used it today until it sh...