Sena Marketing

1. Comunidad
2. Tips & Troubleshooting
3. Update Problem Sena 30K V.3.4

Hi. The latest firmware for the 30K-01 is v3.4. There will be a firmware update coming soon that will add Mesh 3.0. Thank you for your patience.

1. Comunidad
2. General Discussion
3. SF-4 not answering my phone when connect to 2 other SF-4's

Hi Kym. When you start a three-way, Group Intercom, your phone is automatically being disconnected from the SF4 to support the intercom connections with other riders as mentioned here in the User's...

1. Comunidad
2. General Discussion
3. SENA Spider ST-1 & Insta 360 X4

Hi Nick. The Sena MeshPort Red adapter is needed if you want to record multiple riders over Mesh Intercom. Thanks.

1. Comunidad
2. Feature Requests and Suggestions
3. Sena 30k MESH 3.0 update

Hi Peter. The firmware update will be coming soon. Please keep an eye out for it. Thanks.

1. Comunidad
2. General Discussion
3. WAVE Intercom App Now Available!

@... Yes but also keep in mind that everyone can create a Group Mesh so that they can all communicate with each other at the same time and can switch back and forth between Open Mesh and Group Mesh.

1. Comunidad
2. General Discussion
3. SC2 stuck on remote pairing

Hi Milanie Mohd Nor. Please perform a Factory Reset on your SC2 then power it back on and place it into Phone Pairing mode so that it can found when scanning for nearby Bluetooth devices on your ph...

1. Comunidad
2. General Discussion
3. Pairing a Sena PI with a Sena +mesh universal

Anthony Striglia 1. No, the +Mesh does not support the Audio Multitasking feature. No. The +Mesh is only for being paired to a non-Mesh capable Sena headset to allow it to connect and communicate i...

1. Comunidad
2. General Discussion
3. Pairing a Sena PI with a Sena +mesh universal

Anthony Striglia Yes. The +Mesh Adapter allows each Pi headset to communicate in a Mesh Intercom network when they are on the same Mesh Intercom channel.

1. Comunidad
2. Tips & Troubleshooting
3. Does sena pi retain intercom pairing?

Theodore Bell As that is the case, we recommend performing a Factory Reset on both headsets and make sure that the firmware on both of them is up to date then pair them together again to make sure ...