Ken Kimari
- Activité totale 580
- Dernière activité
- Membre depuis
- Abonné à 0 utilisateur
- Abonnés 0 utilisateur
- Votes 0
- Abonnements 186
Commentaires
Activité récente par Ken Kimari-
Just one more thing to check. Make sure you have the most recent update of the Sena Utility app. I remember having a similar problem a few updates back and the older version of the app didn't work...
-
It won't work that way. Your iPod cannot be connected to both helmets at the same time. However you can do music sharing with one 20s connected to the iPod and by following the music sharing inst...
-
Hi Darren - You didn't make any mention of what you did after either shaking both units to put them into pairing mode or pressing the jog button on both units for the required six seconds. If you ...
-
No, worked just fine. You have to delete the previous sena pairing from the iPhone then re-pair the two. Sena 1.7.5 will now show on the iPhone instead of the previous version.
-
Hold the jog dial button down till you hear "intercom pairing". Release then tap the phone button once within 2 seconds. You should then hear "second mobile phone pairing" and then the double beep...
-
Do a fault reset with the SR10 re-pair the SR10 to the headset using second mobile phone pairing and try again.
-
The charge light is very small. Right next to where you plug it in between the plug and the seam.. It's easy to miss seeing it. Starts off red then changes to blue when charged. The led on the si...
-
Perhaps CS was not as familiar with the product as they should have been in the first place. According to what you just said they were half right in that it does work with music playing - if you pr...
-
"Hello Sena" works only in standby mode which means the unit is on but you are not connected to music, phone, intercom or engaged in any other operation. Only way to get voice command to work if y...
-
"Hello Sena" works only in standby mode which means the unit is on but you are not connected to music, phone, intercom or engaged in any other operation. Only way to get voice command to work if y...