SMH10 firmware 5.1.2 upgrading problems
-
Yup have this exact same problem. Been over an hour now and still at 90%.
0 -
Me too, same problem. Been over an hour now and still at 90%.
0 -
Same here. No way out, and stuck with a bricked device. Used USB 3.0 port. Apparently this is too much for poor device. Must be 2.0. Not sure if true.
Tried removing the battery completely, waiting a few minutes, then with/without battery, long press (5s+) on reset button. No change.
All I see is the red charging indicator led.
Will try to call tech support now.0 -
SOLVED!!!!!!
I just spend about 30 minutes with tech support without success.
And BTW, just to reduce the risk of conflict, he recommended that I disabled Bluetooth in Windows (I use Win10Pro 64bit).
For good luck I used a good old USB 2.0 port instead of 3.0
That didn't make any difference, but I kept this setting.
Finally, the guy hinted me that it may be the latest version of the Sena Device Manager (their application) that is the culprit.
By chance, I had an older SenaBluetoothDeviceManagerForWindows-v2.6-setup_x64.exe at hand, so I uninstalled the 3.7.2 version and re-installed the old one. TADAM!!!! It worked.
Hope it does for you too.
For your convenience, I've created a web page so you can download it.
Here: http://ctrnd.com/contact/privatepage/tools-and-utilities
0 -
This solutions worked for me as well, thank you so much Normand
0 -
im just trying it now. using usb 2 and your downloaded file. at moment at 90%
0 -
Right it failed but tied several times and just this second it worked! so a mahoosive thank you!!
0
Accedi per aggiungere un commento.
Commenti
7 commenti