10C EVO HD speakers
Hello guys.
It's too complicated to get HD speakers for my SENA 10c EVO where I live, so I have already swapped the original speakers with much better ones, which I got from a broken headset Philips RB-HF520BE-K, nearly the same size. Pity, SENA does not provide speaker specs, but Philips does: Frequency range: 7 - 40 000 Hz, 40 mm, 16 Ohm and the sound is already much better. My question is, if there is a trigger for the HD speakers (like a resistor somewhere in the 10 pin micro USB connector) and if the HD option in the Sena app for Windows automagically understands that HD speakers (HD accessory) are connected and HD options become available. I reverse engineered the pinouts and connections, but still, don`t know someone owning the HD set so I can diff/measure it. Such post might be not tolerated here, but I have my reasons and SENA were contacted long ago about the issue.
Kind regards.
* PS:
Specs are much appreciated. "It's SENA compatible and HD" is not a description of a product..." All companies are fighting over specs plus/minus Hz/dB and we are here like "If it`s more expensive, it's better", "If it's for motorbikes, it has to be *3.14"... Naaaah...
-
Hi, thanks for the detailed post — great job on the speaker swap and testing!
To your question: Yes, the SENA 10C EVO uses a hardware identifier (likely a resistor or specific pin configuration in the 10-pin connector) to detect the HD speakers. Without that ID, the HD Audio option in the app usually stays disabled, even if you've installed better-quality speakers. So unfortunately, it’s not just about speaker specs — it’s also about how the system authenticates the accessory.
Totally agree with your PS — detailed specs should be standard, especially for audio gear. It’s frustrating when companies prioritize marketing over transparency.
Kind regards.
0 -
Great work swapping in higher-quality drivers! Unfortunately, the 10C EVO doesn’t simply look at speaker performance—it checks for a specific “accessory ID” before enabling the HD mode in the app. In practice, that ID is just a small pull-down resistor (on the accessory plug) that tells the firmware, “Yes, this is the official HD speaker set.” Without that resistor or the genuine HD speaker harness, the Windows app (and the 10C EVO’s firmware) won’t expose the HD options—even if you’ve got better drivers fitted.
0 -
Great to see the 10C EVO HD speakers discussion! I upgraded to these speakers and noticed a significant boost in bass and clarity, especially at high speeds. The beveled design fits my helmet perfectly, reducing ear discomfort. Make sure to update your firmware and Sena app to maximize performance. Highly recommend for an enhanced audio experience!
0 -
It’s interesting to see alternative speaker swaps for the 10C EVO. Frequency range and impedance really do make a noticeable difference in clarity, especially when compared to the original SENA units. Might be worth checking if other similar-sized headset speakers can match that 40 kHz range.
0 -
This is an interesting teardown approach. From what is known about Sena accessories, HD speakers usually don’t rely on a simple resistor trigger. The firmware often checks impedance and possibly an ID pin, but Sena never publishes this clearly, which makes reverse engineering tricky.
0
Accedi per aggiungere un commento.
Commenti
5 commenti