Chris Souris
Shoei Neotec3 w/SRL-3 May 2024 SuzukiGSX-S1000GT+ MySpin app. Retired now, and have been riding for 38 years.
- Attività totali 16
- Attività recente
- Membro dal
- Segue 0 utenti
- Seguito da 0 utenti
- Voti 1
- Abbonamenti 5
Panoramica attività
Ultima attività di Chris Souris-
Chris Souris ha creato un post,
SRL3 Wifi Connection...
Help: I set up my SRL3 WiFi adapter on my network and it updated the firmware fine...once. When I did it again a month or so later to check for a new update, the WiFi adapter couldn't seem to find ...
-
Chris Souris ha commentato,
Hi Will...... I did resolve it by deleting and re-adding the bluetooth profiles. I updated to the latest 1.7.7 yesterday and hard-restarted them both. I have not had the chance to try them out ye...
-
Chris Souris ha commentato,
Update: I tried once again to use the SM10 with my 20S on the 2010 Goldwing. Turning them both on, it still gets halfway through the 'media device connected' message and turns of the 20S headset po...
-
Chris Souris ha commentato,
200-300 yards at best.....zero when line of sight is lost....
-
Chris Souris ha commentato,
The range issue has been like that since day one. My 20S has NEVER worked beyond line of sight, much less more than 300 yards out in the open.....Bluetooth technology is so low powered that it can'...
-
Chris Souris ha creato un post,
20S Headset on 1.7.X shuts down when using the SM10 on a Goldwing...
SM10 hooked via a cable to my 2010 Goldwing; My 20S dual headsets both are on 1.7.X and they shut off when trying to sync up with the SM10. I get halfway through the 'media device connected' messa...
-
Chris Souris ha commentato,
So you have an answer to your question, make sure the mic foam covering is in place, and that the mic is facing in the correct direction. If its an open face helmet, the wind is probably interferin...
-
Chris Souris ha creato un post,
SR10 time-out delay needs to be adjustable through the software.
The SR10 has a time-out delay to return to the audio channel (say back to the 20S headset I have) as standard, or the PTT can be tapped to manually return it. I'd like to see the time-out adjustabl...
-
Chris Souris ha commentato,
Periodically when I plug the mini usb cable into the 20S headset to charge/change settings, it will not light up. I remove and re-insert it and it works fine.....just a connection issue.
-
Chris Souris ha commentato,
Is it possible that the 'static' (I feel it sounds more like the channel being switched back and forth on the 20S) is due to having HD voice enabled, there-by using more channels and generating low...