Johnv
- Attività totali 19
- Attività recente
- Membro dal
- Seguiti 0 utenti
- Seguito da 0 utenti
- Voti 0
- Abbonamenti 5
Panoramica attività
Ultima attività di Johnv-
Johnv ha commentato,
I sent mine back and got a replacement and yes the FM is 1000% better than my original. But 1000% of nothing is still not good. Sure it now works where as before it did not work at all but it only ...
-
Johnv ha commentato,
Well its a strange one alright. I updated to 1.2 last night and tried again this morning. Changed it over to Europe as a zone and of the 3 stations the other headsets pick up the 20S will pick up j...
-
Johnv ha commentato,
It should not matter about the country zone as a frequency is a frequency. If you can tune to it you should be able to receive it. However there is no New Zealand country zone there so it is set fo...
-
Johnv ha commentato,
Well I had to send my unit back to Australia to get it fixed. Arrived back today (really fast turn around) with a note in it saying unit replaced and tested. Does not say what they tested. Tried it...
-
Johnv ha commentato,
I have the Neotec flip up and my mic never gets caught on the chin curtain. I have used both the 20S and currently using a Cardo G9x (may not switch back when the 20S comes back from its being repl...
-
Johnv ha commentato,
What audio multi-tasking? Just another joke feature like the FM radio. Both don't work at all. It was advertised as being able to listen to your music while the GPS gave instructions. Nup, not gunn...
-
Johnv ha commentato,
Well it seems like Sena are not standing by their product after all. Finally got a reply and they asked for proof of purchase. I provided this and then they tell me that they can't replace mine and...
-
Johnv ha commentato,
Well I put a request in about the FM radio and after a week have not heard anything. Have been advising all my mates not to purchase one if they are expecting a radio in the thing to actually work.
-
Johnv ha commentato,
My understanding is that the flashing means the unit is in standby mode just waiting for something. The units will spend most of their time in standby. Also you don't want a steady LED. An LED that...
-
Johnv ha commentato,
Didn't handle the rough weather here very well. Had a huge wind today that was blowing me all over the show and all I got out of the 20S is continuous "say a command". Not sure what was triggering ...