Bill Henning
- Attività totali 75
- Attività recente
- Membro dal
- Segue 0 utenti
- Seguito da 0 utenti
- Voti 3
- Abbonamenti 20
Commenti
Attività recente di Bill Henning-
Ken, I use ER6i's and my passenger uses Etymotic MC5 in ear buds and neither of us has any buzz or hum worth mentioning. I am familiar with that hum from a ground loop problem I had that was solved...
-
Bob, mine did the same thing! FM ON, FM OFF. If you have something plugged into the AUX input remove that and see how it works then. Sena told me that when the AUX input is playing you can't hav...
-
If you are having a problem with tap-tap not working to get into standby mode the Sena guy suggested that perhaps going back to firmware 1.0 might help, since they reduced the motion sensor sensiti...
-
Robert, perhaps I should have said sensitivity is set at HIGH by the Sena configuration software. Even so it did not respond to numerous tap-tap's, either with or without gloves on. In any case sin...
-
Plugged the speakers back in and that made no difference in reception, still spotty. If I don't get a fix for this I'll be returning my units. Too bad.
-
Does it use the earphone wires as antennas? I ask because I have removed those in favor of earbuds. Now my radio reception has gone from good to poor. I think I will plug the speakers back in ag...
-
I just put a piece of medical waterproof adhesive tape over the hole. Very easy to do and I think that will keep the water out.
-
Jeroen, I am in Denver, Colorado, USA. I wonder if there is a difference in FM radio transmission strength between our two countries?
-
Maybe you guys have defective units. I get stations on my 20S that my 2012 BMW R1200RT factory radio doesn't pick up. It works as well as my car radio. Sounds like something is wrong.
-
How about a forum area devoted to the 20S like some other models have? Just got mine and slogging through this single disorganized thread is difficult.