Peter

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

Hi Rich, ok, I think I understand what you're talking about now. I read your original message as meaning that the repeater _never_ stops transmitting. Yes, my local repeaters to continue to transmi...

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

Hmm, stranger and stranger. Do you have another device to plug in to the sp/mic jacks of the radio that has a PTT button? Like a headset or external speaker/mic? If so, see if the radio will let yo...

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

Ok, well that behavior actually sounds normal. Let me ask what may be a stupid question, are you tapping the PTT button or holding it? Just to be pedantic, my experience is: press and hold the rem...

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

Hi RIch, well, that's one difference in our setup, my SR10 isn't paired as either phone or media. I used the multipoint pairing for it (hold the jog wheel on the SMH10 until it says 'intercom pairi...

1. Community
2. Feature Requests and Suggestions
3. SR10 PTT Reprogram?

If the radio's PTT button works during receive, and a different external PTT, like on a Speaker/Mic or headset also works during receive, then my guess is that you either have a bad cable between t...

1. Community
2. Feature Requests and Suggestions
3. more volume would be nice.

@ Sena, good to hear this will finally be addressed. I hope that there's also improvement on the bottom end of the volume range as well. Since the unit won't play loud enough with the speakers to u...

1. Community
2. Feature Requests and Suggestions
3. more volume would be nice.

Another +1, the volume is sufficient when riding without earplugs, but with earplugs in, it can't be set loud enough to hear properly.

1. Community
2. Tips & Troubleshooting
3. Are either of the SR10 input jacks noise-gated?

The squeal you're hearing is most likely alternator noise from your bike's electrical system. When you power the SR10 from the bike and connect it to other bike-powered audio devices, you create a ...

1. Community
2. Tips & Troubleshooting
3. What type of Hirose connector is needed for the radio connection on the SR10? will a HR10A work?

Since I have to build a custom ground-loop isolator for my two-way radio, it'd be nice to use the same connector as the SR10 to keep the cabling simple and clean. Getting an actual part number conf...

1. Community
2. Tips & Troubleshooting
3. What type of Hirose connector is needed for the radio connection on the SR10? will a HR10A work?

I just received a set of Hirose connectors, looks like the HR10A is the right one, specifically HR10A-7P-6P(73) to plug in to the SR10. The connector on the SR10 itself appears to be a HR10A-7R-6S(...