Spider st1 mesh issue

Bernt Ebeling

May 25, 2026 22:16

Hi, when I tap the mesh button for 1 sec on my Spider ST1 it will not start mesh (LED will not switch to green). Blue LED continues blinking. Have tried both Fault reset and Factory reset without any result. Firmware is updated. Any ideas what could be the problem?

0

• 

  Franco Ponce

  October 07, 2026 04:22

  I have the same problem than you. Did you resolve it? thank you

  0
• 

  Bernt Ebeling

  October 08, 2026 16:33

  Hi, the Sena support could not tell why I have this malfunction. My device warranty has expired, so it doesn’t make sense to send in the device for repair and not knowing what the cost would be.

  0

Please sign in to leave a comment.