Ken Kimari
- Total activity 580
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 186
Comments
Recent activity by Ken Kimari-
First thing I would do is make sure your 20s has the most current firmware - 1.7.1. Once upgraded I would do both a fault reset and a factory default reset. Delete the bluetooth pairing for the 2...
-
Any chance you can return your unit from where you bought it? If the latch you have is not metal it is a very old unit. The metal latches have been out now for over a year. Mine is one of the ol...
-
Once you get everything working I think you will like it over the Cardo. With all the options it can be a little confusing to operate. Most of the complaints I've seen about the 20s ended up being...
-
Check to see if your mount clamp to the helmet is too tight. If the bolts are torqued too tight it can pull the bottom part of the bracket towards the helmet and bend it away slightly from the lat...
-
one more thing. Check the slot in the unit where the latch catches and make sure it is clean and smooth. I have heard that sometimes during the manufacturing process that slot is not quite finish...
-
Hi Terry. I had the same issue when new but it's fine now. Best practice is to hold onto the base and place the unit in the slot. Continue to hold the base, press the release button and at the sa...
-
Take a look at this. Audio from Zumo may be at fault. http://www.chainspeed.co.uk/pages/Garmin-Zumo-660-Help.html
-
Is the noise coming from you or your friend's? When in intercom microphones are fully active all the time (full duplex) no vox. Button mic has less noise cancelling than button mike. May try rep...
-
sorry meant to say button mic has less noise cancelling than boom mic
-
Simon, When he calls on the intercom the units connect and your music is interrupted automatically. Upon disconnect your music should resume.