Ken Kimari
- Total activity 580
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 186
Comments
Recent activity by Ken Kimari-
This will walk you right through it! https://www.youtube.com/watch?v=wgCXujxoVkg
-
This will walk you right through it! https://www.youtube.com/watch?v=wgCXujxoVkg
-
Might not be clear enough. For normal and universal intercom with the Sena you use the same button to connect and disconnect to the Scala. For the person using the Scala it is the button used to ...
-
Ok, When you are paired using the universal intercom you can use the same button on the sena to connect or disconnect the intercom. On your Scala you use the button that connects and disconnects a...
-
Anders- Please read carefully the instructions for the SRL. Pg 33 Universal intercom setup which is unique to Sena products. It uses phone pairing which is universal to all bluetooth systems, unlik...
-
Hmm. I don't get very much wind noise. Almost zero. I ride a dual sport bike which is louder than the tourer I had. Make sure the mic is pointed in the right direction and advanced noise control...
-
I second Paul's advice. The positioning of the speakers is critical. Your ear canal must align with the center of the speaker. Even just a 1/4" off will noticeably reduce the volume level. I ha...
-
Fred - If you have the 30k take advantage of the Mesh connection rather than the intercom pairing. You can listen to music and have the intercom on at the same time. Mesh pairing rather than int...
-
Sorry RedOne The aux input does not pass thru audio when the 20s is off. The 20s needs to be operating for aux audio to work. Carry some earbuds if you must listen to music. Keep your 20s charg...
-
Ben Put both units in intercom pairing mode. Once the units are in pairing mode, press the intercom button once on just one of the units. After a few seconds both should pair up. Sometimes it m...