Robert Godoy

1. Motorcycles
2. 10C

Peel off each cover of the hook and loop fasteners for speakers to expose the adhesive surface. Then, attach the fasteners to the ear pockets inside the helmet. Attach the speakers to the hook a...

1. Motorcycles
2. SMH10

When the SMH10 is not working properly or is in faulty status for any reason, you may reset by pushing the pin-hole reset button at the back of the headset main unit. Insert a paper clip into the r...

1. Motorcycles
2. 20S

You can check the battery level in two different ways when the headset is powering on. LED IndicatorWhen the headset is powering on, the red LED flashes rapidly indicating the battery level.4 flash...

1. Accessories
2. RC3

1. Turn on the 10R and the RC3. 2. Press the Center Button for 10 seconds to enter the configuration menu. Tap the (+) Button or the (-) Button until you hear a voice prompt saying, "Remote control...

1. Accessories
2. RC4

1. Turn on the 10R and the RC4. 2. Press the Center Button for 10 seconds to enter the configuration menu. Tap the (+) Button or the (-) Button until you hear a voice prompt saying, "Remote control...

1. Motorcycles
2. 10C EVO

Timelapse Video Mode Timelapse video records series of photos at timed intervals and makes it into a video.  Loop Recording Mode Loop Recording mode continuously records videos to create footage...

1. Motorcycles
2. 10C EVO

You can raise or lower the volume by rotating the Jog Dial. Volume is set and maintained independently at different levels for each audio source, even when the headset is rebooted.

1. Motorcycles
2. 10C

You can easily adjust the volume by rotating the Jog Dial. You will hear a beep when the volume reaches the maximum or minimum level. The volume is set and maintained independently at different lev...

1. Motorcycles
2. 10C

If you have a full face helmet, you can use the wired microphone. Attach the included hook and loop fastener for wired microphone to the inside of the helmet’s chin guard. Attach the wired mic...

1. Accessories
2. RC3

1. Turn on the 10U and the RC3. 2. Press the (+) Button for 10 seconds to enter the configuration menu. Tap the (+) Button until you hear a voice prompt saying, "Remote control pairing". Press the ...