Juan - Sena Support

1. Cycling & Outdoor
2. EXPAND BOOM

If you want to restore the headset to factory default settings, use the Factory Reset in the configuration menu. The headset automatically restores the default settings and turns off. To do a Facto...

1. Cycling & Outdoor
2. EXPAND BOOM

When the Sena Expand Boom is not working properly or is faulty for any reason, you may reset it by pushing the pinhole reset button at the back of the headset main unit.  1. Rotate the speaker pad ...

1. Cycling & Outdoor
2. EXPAND BOOM

The Sena Expand Boom can be paired with up to three other headsets for Bluetooth intercom conversation. 1. Turn on the two Sena Expand Boom headsets (A and B) that you would like to pair with each ...

1. Cycling & Outdoor
2. EXPAND BOOM

Initially Pairing the Expand BoomThe headset will automatically enter the phone pairing mode when you initially turn on the headset or in the following situations: • Rebooting after executing the F...

1. Cycling & Outdoor
2. EXPAND BOOM

1. When you have an incoming call, tap the Center Button to answer the call.2. To end a call, press and hold the Center Button for 2 seconds until you hear a mid-tone single beep, or wait for the c...

1. Cycling & Outdoor
2. EXPAND BOOM

Powering OnPress and hold the Center Button and the (+) Button at the same time for 1 second to power on. Powering OffTap the Center Button and the (+) Button simultaneously.

1. Cycling & Outdoor
2. LATITUDE SX

When the USB charging & data cable connects a power supply to the system, the system will automatically be turned off and a fault reset will occur. Note: Fault Reset will not restore the headset t...

1. Cycling & Outdoor
2. LATITUDE SX

To erase all of your settings and start fresh, the system can be restored to factory default settings using the factory reset.        

1. Cycling & Outdoor
2. LATITUDE SX

FM Radio On FM Radio Off

1. Cycling & Outdoor
2. LATITUDE SX

Seek Stations Forward Save Stations 1. Enter preset selection mode. 2. Navigate forward or backward through preset stations that you want to store. 3. Save station to the preset number or delete...