Sena
- Total activity 969
- Last activity
- Member since
- Following 0 users
- Followed by 1 user
- Votes 5
- Subscriptions 284
Comments
Recent activity by Sena-
Submit a ticket to the Sena Help Desk and our Technical Support department will assist you. http://support.sena.com/anonymous_requests/new
-
@Billhuffmansr: What djj said is correct. The SMH5-FM would be considered as "Other" so all you need to do is power it on and hit the Next button.
-
@Diptwattle: You can disable the motion sensor so that you will no longer hear the "Say a command" voice prompt. For more information, refer to this F.A.Q. http://support.sena.com/entries/10797348...
-
Perform a Factory Reset on your 20S. To find out how to perform a Factory Reset on the 20S, you can refer to the 20S User's Guide under the Support Documents section here http://www.sena.com/produc...
-
@Belot77: Yes. The "Hello Sena" voice command can only be used during Standby Mode. You would need to activate the voice command system by double tapping the main unit twice or tapping once on the ...
-
2. When in group intercom, no one could leave the group by using the double-tap and saying "group intercom". I don't know of any other way for a person to leave the group. Is there one? Since i...
-
@Dan: No it will not interrupt the intercom. GPS Pairing will allow you to hear the instructions from the GPS while talking over the intercom. @Marc: If you can listen to the music from your Zumo...
-
@Inspector069: We apologize as we were referring to Case #4 in the User's Guide and didn't see the link that you posted about the GPS Pairing configuration. With that said, we have notified our dev...
-
1. Rotate while pressing the Jog Dial clockwise to search up the station dial or counter clockwise to search down the station dial. 2. If the tuner finds a station while searching frequencies, it s...
-
Michael: Make sure the firmware on the 20S has been updated to the latest version which is v1.6. Then, remove the 20S from the list of Bluetooth devices on your phone. Next. perform a Factory Reset...