Keith
- Total activity 133
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 16
Comments
Recent activity by Keith-
With version 1.3, I've found that the "Hello Sena" command stops working after 60 seconds in stand-by mode on my 20S units. Saying "Hello Sena" works fine 15, 30, 45 and even 55 seconds after any a...
-
I got this response from the Sena engineer regarding how fixing the 60 second mic cut off seen in firmware versions 1.3 and 1.4 possibly reducing stand-by time: ++++++++++++++++++++++++++++++++++++...
-
It's not your bike being too loud. I don't know why the Sena engineer would say that. Both of my 20S units stop responding to "Hello Sena" after 60 seconds in stand-by mode even when I'm in my hous...
-
Hi JHLR, If you are running firmware version 1.4 and still not able to answer the phone with the LOUD "Hello", then maybe it wasn't version 1.4 that got it working for me. Maybe it was simply my 2 ...
-
Hi Brent, I hope Sena tracks bugs in a system that can be referenced when a customer reports a problem. If there isn't a system for the Sena engineers to check for known bugs, the tech support engi...
-
I sent a message to the Sena engineer I've been working with to ask him how they track issues and when the "Hello Sena" command 60 second timeout issue will be fixed. Below is the response I got: +...
-
As I already have above on this thread, I can testify that the "Hello Sena" command worked no matter how long either of my two original 14XXXXXX 20S units were in stand-by mode running version 1.2....
-
Hi Kevin, You may have already done so, but you should update to the latest firmware version (currrently at 1.4.1). Also, make sure the mic is right in front of your mouth and pronounce the command...
-
I'm working on a few issues with Sena support. The "Hello Sena" command is one of the issues. I just got this response from them regarding that issue: ++++++++++++++++++++++++++++++++++++++++++++++...
-
I agree. For me, on my original S/N 14XXXX units, the mic always being on reduced stand-by battery life by 33% (~30 hours running 1.3 with mic cutting off at 60 seconds vs ~20 hours running 1.2 and...