Controlling with a Sena headset or a non-Sena headset.
Here is how you can control the Sena Prism over Bluetooth with a Sena headset that uses a Jog Dial:
To cycle through the different camera modes on the Prism, press down on the Jog Dial and rotate.
To use the current camera mode, hold down the Jog Dial for one second. On the video mode, holding down the Jog Dial for one second will start recording video. To stop recording video, hold down the Jog Dial again for one second.
While you are recording video, you can take a still photo by tapping the phone button once.
To put the Prism into Sleep Mode and temporarily turn off the camera and conserve battery, tap the phone button three times.
To wake the Prism from Sleep Mode, tap the phone button three times.
If the Prism has been disconnected from the Sena headset, tap the phone button three times.
Here is how you can control the Sena Prism over Bluetooth with a Sena headset that uses three buttons:
To cycle through the different camera modes on the Prism, press down on the Plus (+) or Minus (-) button for one second.
To use the current camera mode, hold down the Center button for one second. On the video mode, holding down the Center button for one second will start recording video. To stop recording video, hold down the Center button again for one second.
While you are recording video, you can take a still photo by holding down the Center button for three seconds.
To put the Prism into Sleep Mode and temporarily turn off the camera and conserve battery, hold down the Minus (-) button for three seconds.
To wake the Prism from Sleep Mode, hold down the Minus (-) button for three seconds.
If the Prism has been disconnected from the Sena headset, tap the Plus (+) button and the Minus (-) button at the same time.
Here is how you can control the Sena Prism using a non-Sena headset:
To use the current camera mode, use the operation to start a phone call on the non-Sena headset.
If you are recording a video in the Video Mode, use operation to start a phone call on the non-Sena headset. If you are recording a video in the Video Mode, use the operation to end a phone call to stop the video recording.
To start a Time-lapse Video recording, use operation to start a phone call on the non-Sena headset. To stop recording a video in the Time-lapse Video mode, use the operation to end a phone call to stop the video recording.
Video:
Comments
0 comments
Article is closed for comments.