Phone Pairing
There are three ways to pair the phone.
Initially Pairing the SPIDER ST1
The headset will automatically enter the phone pairing mode when you
initially turn on the headset or in the following situation:
• Rebooting after executing Factory Reset.
1. Press and hold the Phone Button and the Jog Dial for 1 second.
2. Select SPIDER ST1 in the list of Bluetooth devices detected. If your mobile phone asks for a PIN, enter 0000.
Pairing When the SPIDER ST1 is Turned Off
1. While the headset is off, press and hold the Phone Button and the Jog Dial until the LED flashes red and blue alternately and you hear a voice prompt, “Phone pairing.”
2. Select SPIDER ST1 in the list of Bluetooth devices detected. If your mobile phone asks for a PIN, enter 0000.
Pairing When the SPIDER ST1 is Turned On
1. While the headset is on, press and hold the Phone Button for 5 seconds.
2. Select SPIDER ST1 in the list of Bluetooth devices detected. If your mobile phone asks for a PIN, enter 0000.
Comments
0 comments
Article is closed for comments.