Ken Kimari
- Total activity 580
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 186
Activity overview
Latest activity by Ken Kimari-
Ken Kimari commented,
SC10UA19English8.1 Intercom Pairing8.1.1 Pairing with Other Headsets for IntercomConversationThe SC10UA can be paired with up to three other headsets forBluetooth intercom conversation.1. Turn on t...
-
Ken Kimari commented,
Take a look at the Sena Pi. I have a pair of these and they work great. Fits on the strap of most helmets, unobtrusive, rechargeable, Have had these for several years now.
-
Ken Kimari commented,
I believe there is an earbud port on the front of the clamp mount just above where the microphone plugs in. It's covered by a rubber flap. The clamp mount is pretty much the same as the one for m...
-
Ken Kimari commented,
hold jog dial down until you hear intercom pairing. Do the same with the second unit. Both units will be sounding deedle deedle through speakers. Then tap the jog dial once on only one of the un...
-
Ken Kimari commented,
You can go with a bluetooth dongle which plugs into the radio then pair through phone pairing (either primary or second mobile phone pairing). PTT is wireless to the dongle and can mount on handle...
-
Ken Kimari commented,
Paul - once both units are in pairing mode, tap the jog dial once on either the SMH10r or the SMH5 - not both. Give it a few seconds (give or take 15 seconds) then the actual pairing should occur.
-
Ken Kimari commented,
Should be able to. Put both units into "intercom pairing". You should hear a "deedle dee" tone from both units when in pairing mode. Then tap the jog dial on the smh5 once. It may take a few se...
-
Ken Kimari commented,
Noname - First of all, my comments were made 3 years ago and the app you referred to came out after that. Secondly, if you look at the compatibility for the newer app, it does not show the SMH 5 l...
-
Ken Kimari commented,
Try a fault reset on both units as well as a factory reset to clear all pairings.
-
Ken Kimari commented,
Try a fault reset on both units as well as a factory reset to clear all pairings.