![chris olson](https://secure.gravatar.com/avatar/3bbe1d93bfcf1596ffb1d472b0ff0447?default=https%3A%2F%2Fassets.zendesk.com%2Fhc%2Fassets%2Fdefault_avatar.png&r=g)
chris olson
- Total activity 11
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 4
Activity overview
Latest activity by chris olson-
chris olson commented,
Monlin(Mengln), The Sena marketing lingo for the auto on / off feature is somewhat lacking in clarity. Supplying 5V will only charge the internal battery. The "auto" part happens when the SR10 se...
-
chris olson commented,
Bill, the fact that Escort has an issue in this area is widely known to what Ken would call the MacGyver crowd. Escort's solution is that they sell their own adaptor which is what I use. Its one...
-
chris olson commented,
Bob, Ken ... You don't need the adaptor. The SR10 unit itself recognizes the difference between 12 volts and usb 5.1. I know because I cut off the adaptor and used the remaining cord to wire dire...
-
chris olson commented,
I'm running a Kenwood 3101 with a Passport radar on my SR10. The Passport has the ground loop isolator sold by Passport (at an exorbitant cost!). A Samsung phone connected to a Zumo 660 are also ...
-
chris olson commented,
Hi Sena Technologies, In Feb it was 2 months. Its now two months and I believe your customers deserve better than your latest response. We are not happy being patient, we are most unhappy. A de...
-
chris olson created a post,
SMH10R Battery Pack Design Options
1) The cord should exit downward from the middle of the pack rather than from the side. This allows a much cleaner installation so you don' have the 90 degree bend which requires a piece of tape t...
-
chris olson created a post,
Operating Voltage Requirement
What is the operating DC voltage requirement for the SR10? Is it a nominal 5 volts (4.75 - 5.25) based on the USB charging cable? I need to wire directly rather than using the cigarette lighter s...