beans
- Total activity 124
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 50
Comments
Recent activity by beans-
- delete all the paring in your phone - reboot your phone - down grade the smh10 firmware to see if an older firmware will work for your phone - https://support.sena.com/hc/en-us/community/posts/11...
-
You should do a factory reset on your SMH10 and try again.
-
GRV, You did not say how you are doing it. So perhaps you do not know how? So go to page 30 and 31 in the manual https://www.sena.com/wp-content/uploads/2016/11/UsersGuide_20S_v1.7_en_161115.pdf Yo...
-
Keith, You should try rebooting your music source (or your phone), if you have tried everything on the headset. Sometimes the Bluetooth stack on the music source/phone can be the issue. Also, if yo...
-
Paul, Make sure that the right speaker is centered in your ear. Try moving it around. You can also test this by removing it from the helmet and cup the speakers with your hands and put them in you...
-
If it has been sitting out for long, the battery is completely discharged. Try to leave it in the charger longer. The small charge light is right next to the charger plug on the 20S. You can also h...
-
Hey Tim, Did you also get a replacement cable, if not it might be bad cable? If you have a phone paired with 20, try deleting it. Isolate the 20S and Freewire, do not pair anything else to the 20s....
-
I would suggest the following pairing Pair the 20S to Freewire using phone pairing Pair the GPS to 20S, using secon phone pairing Pair the phone to the GPS. The GPS can channel phone calls to the 2...
-
I would suggest the following. 1. factory reset the 20s 2. delete the 20s on your phone 3. factory reset the freewire Make sure you are doing the factory resets correctly. Pair the 20S to your free...
-
Look at the note #2 in page 31. Note: 2. To activate the voice command during non-stand-by functions, tap the Ambient Mode Button or double tap the surface of the main unit. When you are in music...