Chris
- Total activity 173
- Last activity
- Member since
- Following 1 user
- Followed by 0 users
- Votes 59
- Subscriptions 45
Comments
Recent activity by Chris-
Always after an update do the fault reset on back of unit and then do a factory reset in config menu. clear pairing on your phone and gps, repair to the phone and gps. do not use the garmin smart p...
-
Dave, i had a ticket in with sena about this issue, it was my sole reason to upgrade to the harmon k unit from my older 50s. i did not want to have to keep turning off the mic during mesh just to h...
-
did you figure it out?
-
Dave I saw a SENA press release saying there is a chip shortage and they will discontinue fm on the cheaper models. For 50 series we still get voice commands via "Hey Sena" not hello sena and Fm. I...
-
yes one or 2 depending on conditions
-
Which 50s are you using? 50s-01 or 50s-10? If the original 50s check the mic orientation. The fin should be facing outwards away from lip.Check the groups mic orientation. Then check a setting in t...
-
First try using a port on the back of the computer. If it doesn’t work then or its a laptop you will have to disable the windows driver signature requirement.Press and hold the Shift key on your ke...
-
Hey try the new firmware v2.0.2. They did some mic sensitivity problems for me in the update. I see in the 50s-01 previous version firmware they tweeked the aux output steps. Im interested in your ...
-
The v2.0.2 fixed my mic issue which was wind noise would cause the new mic to go open during a mesh conversation. In the app the setting called intercom audio multitasking sensitivity now works on ...
-
Is the other unit a 50s or 50r? If so just lift up the antenna and push the mesh button. Or say hey sena mesh on.