andreas.ao.otte
- Total activity 16
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 6
Activity overview
Latest activity by andreas.ao.otte-
andreas.ao.otte commented,
I got the SRL Mesh and the SRL3 for my Shoei Helmets.. There recently was a new firmware, which is not listed in the firmware history. Sena is very slow in updating their web pages. My SRL mesh for...
-
andreas.ao.otte commented,
Same problem ! "OK Google" works, Mesh and phone communication work. Sena voice commands work 1 out of 10 tries..
-
andreas.ao.otte commented,
I can confirm. that the SRL3 in my NeoTec3 barely picks up any command. Is Sena reading forum posts ? Communication via Mesh or Phone calls are good, though
-
andreas.ao.otte commented,
I assume Sena guys our busy finalizing their all new Shoei Com-Link System for the 3rd generation helmets Neotec 3 and GT-Air 3. We will get new information, when they are done :-) No wonder I got...
-
andreas.ao.otte created a post,
SRL Mesh Firmware 1.3 - Revision History available ?
Via WiFi i got version 1.3. The firmware release notes on Sena.com haven't been updated. Any know or noticed any differences ?
-
andreas.ao.otte commented,
Please be aware, there are 2 different hardware revisions, with 2 different firmware releases. For hardware revision #1 V1.3.1 is the latest firmware. 2.2.1 is for hw#2 Part-Nr. 50S-10 1.3.1 is ...
-
andreas.ao.otte commented,
I got really helpful feedback from a Sena expert I would like to share with you. ----begin if quote--- -Following customer feedback that the microphone opened too easily in mesh because of wind or ...
-
andreas.ao.otte commented,
Let's keep in mind, that there are two hardware revisions of the same product. As they have different Chipsets and different firmware versions, let's not mix them up. Old hardware, from 2021 still ...
-
andreas.ao.otte commented,
Thank you Daniele ! So i am not the only one, still suffering. A bit disappointing there is no reaction from SENA after all these months.
-
andreas.ao.otte commented,
As this issue is here for quite some while. Am i the only one with an RT1 (revision#1) how still has this issue ? I'm on the latest firmware 1.2.1 (2nd of june 2023). I went back to the OLD V1.0.3...