Using the Glued Surface Mounting Plate

 If you cannot install the clamp unit on the helmet, you can use the glued surface mounting plate to attach the clamp unit to the surface of the helmet.

1. Clean the area on the left side of the helmet where you will attach the glued surface mounting plate with a moistened towel and dry thoroughly.
2. Peel off the cover of adhesive tape of the glued surface mounting plate and attach it to the helmet.
3. Make sure that the glued surface mounting plate sticks on the helmet firmly. Maximum adhesion occurs after 24 hours.

CAUTION: Sena recommends using the clamp unit. The glued surface mounting plate is provided for convenience, but is not the recommended mounting method. Sena is not responsible for its use.

4. Attach the main unit to the glued surface mounting plate until you hear a click.The main unit is now fastened to the clamp unit.